Cartridge valve repair easy to do!
Repairing a type of modern cartridge tap can be one of the easiest repairs to make at home. Experience in v with plumbing. In fact, you can even coach a person on the phone on the whole process while getting good results. All you need is special attention, and you're done in no time!
General problems
The most common problems encountered in cartridge valves are usually caused by a problem in the inner cartridge, which wears and tears over time. Nevertheless, there is no need to worry, because this type of faucet was created for the sake of simplicity of repair.
To begin Purge lines
To begin, you must purge your water pipes. To do this, you must turn off all the water supply to your faucet. Try to look under your faucet and you can see the shutoff valve that cuts off the water source. If you do not have one near your faucet, you will need to close the main valve.
If you need to take care of the main valve, note that purging will take longer. Most households have a stop valve function that is placed directly under the sink, so this is the least of the possibilities you need to close the main valve.
After turning off the water source, open the tap. Let the water continue to flow. Try to wait until all the water in the pipes has drained and, before going to the next step, first check if the water pipes are really empty.
Work on the tap
Now, to start working on the faucet, you have to remove the handles from the sink. They should be unscrewed. Locate the protective cap and remove it. This is where you will usually find the screw. You can use a butter knife or a screwdriver to do the trick. In doing so, try to be very careful not to scratch it. In this way, he would still be beautiful after work. You can now start unscrewing the buttons until you remove them completely.
If you already know the type of cartridge you need, the better. If you do not, you can simply bring your old record to your local material and people there will be able to help you.
Once the new cartridge is obtained, turn it over and install it. Then replace the buttons. When you're done, try testing the water. If the test runs smoothly, you're done.
However, if you encounter water leaks during the test, you must make a new adjustment. Close the water source and remove the buttons once more. Try to check and make sure you have placed the cartridge in the correct position. If this is not the case, try placing it in the right place.
